PIAGGIO Beverly 300ie - Service manual > Rear/Front brake calliper
Rear brake calliper
Removal
- Remove the rear wheel.
- Remove the two rear brake calliper devices fastening them to the support as shown in the picture.
N.B.
SHOULD THE BRAKE CALLIPER BE REPLACED, BEFORE REMOVING THE FITTINGS FIXING THE CALLIPER TO THE SUPPORTING BRACKET, FIRST LOOSEN THE OIL HOSE FITTING AFTER HAVING EMPTIED THE SYSTEM OF THE CIRCUIT BEING INSPECTED.
Refitting
- Follow the removal procedures but in reverse order and tighten to the prescribed torques with the recommended product.
Recommended products
Loctite 243 Medium-strength threadlock
Medium Loctite 243 threadlock
Locking torques (N*m)
Screw tightening calliper to support 20 ÷ 25
If the calliper is replaced:
CAUTION
ONCE REFITTING IS FINISHED, BLEED THE SYSTEM.
CAUTION
ALWAYS USE NEW COPPER WASHERS.
Locking torques (N*m)
Rear brake calliper-pipe fitting 20 ÷ 25
Front brake calliper
Removal
- Remove the two retainers fastening the front brake calliper to the support as shown in the picture.
N.B.
SHOULD IT BE NECESSARY TO REPLACE THE CALLIPER, FIRST LOOSEN THE FITTING CONNECTING THE PIPE TO THE BRAKE CALLIPER.
Refitting
- To fit the calliper, follow the above operations but in reverse order.
Locking torques (N*m)
Screw tightening calliper to support 24 ÷ 27
If the calliper is replaced:
CAUTION
ALWAYS USE NEW COPPER WASHERS.
CAUTION
ONCE REFITTING IS FINISHED, BLEED THE SYSTEM.
Locking torques (N*m)
Brake fluid pipe-calliper fitting 20 ÷ 25
See also:
PIAGGIO Beverly 300ie - Service manual > Interventions rules
WARNING BRAKING SYSTEM FLUID IS CORROSIVE: ALWAYS WEAR PROTECTIVE GLOVES. IN THE EVENT OF ACCIDENTAL CONTACT WITH YOUR EYES, RINSE THE CONTACT AREA WELL WITH ABUNDANT WATER.
PIAGGIO Beverly 300ie - Service manual > Rear/Front brake disc
Rear brake disc These vehicles may feature a rear wheel with integrated hub or with a hub independent from the wheel. Removal REAR WHEEL WITH INTEGRATED HUB Remove the rear wheel. Act on the disc five fixing screws shown in the picture.
