Suzuki Burgman 400 - Service manual > Air Valve Removal and Installation

Removal

1) Remove the wheel assembly. Refer to "Front Wheel Assembly Removal and Installation" and "Rear Wheel Assembly Removal and Installation".

2) Remove the tire. Refer to "Tire Removal and Installation".

3) Remove the air valve (1) from the wheel

Installation

Install the air valve in the reverse order of removal. Pay attention to the following points:

• Any dust or rust around the valve hole (1) must be cleaned off.

• Install the air valve in the wheel.

! CAUTION

• Be careful not to damage the lip of valve.
• Replace the air valve with a new one.

NOTE To properly install the valve into the valve hole, apply a special tire lubricant or neutral soapy liquid to the valve.

2. Wheel
3. Valve
4. Valve lip

Wheel Balance Check and Adjustment

Check and adjust the wheel balance in the following procedures:

1) Removal the wheel assembly. Refer to "Front Wheel Assembly Removal and Installation" and "Rear Wheel Assembly Removal and Installation".

2) Check the wheel balance using the balancer and adjust the wheel balance if necessary.

! CAUTION For operating procedures, refer to the instructions supplied by the wheel balancer manufacturer.

3) When installing the balancer weights (1) to the wheel (2), set the two balancer weights on both sides of wheel rim.

! CAUTION Weight difference between the two balancer weights must be less than 10 g.

4) Recheck the wheel balance.

5) Install the wheel assembly. Refer to "Front Wheel Assembly Removal and Installation" and "Rear Wheel Assembly Removal and Installation".

Specifications

Service Data

Wheel

Unit: mm (in)

Tire

Tightening Torque Specifications

NOTE The specified tightening torque is also described in the following.

Reference: For the tightening torque of fastener not specified in this section, refer to "Tightening Torque Specifications".

Special Tools and Equipment

Recommended Service Material

NOTE Required service material is also described in the following.

Special Tool

09900-18710 Hexagon socket (12 mm)

09900-20607 Dial gauge (1/100 mm, 10 mm)

09900-20701 Magnetic stand

09900-21304 V-block (100 mm)

09913-50121 Oil seal remover

09913-70210 Bearing installer set

09921-20240 Bearing remover set

09941-34513 Steering race installer

See also: