Yamaha XMAX YP125R - Service manual > Electrical system

Checking and charging the battery

Refer to "ELECTRICAL COMPONENTS"

Checking the fuses

Refer to "ELECTRICAL COMPONENTS"

Replacing a headlight bulb

To replace a high beam headlight bulb

1. Remove:

• Front cowling assembly

2. Remove:

• Headlight bulb cover "1"

3. Remove:

• Headlight bulb holder "1" (with the headlight bulb)

4. Remove:

• Headlight bulb

WARNING

Since the headlight bulb gets extremely hot, keep flammable products and your hands away from the bulb until it has cooled down.

5. Install:

• Headlight bulb

Secure the new headlight bulb with the headlight bulb holder.

NOTICE

Avoid touching the glass part of the headlight bulb to keep it free from oil, otherwise the transparency of the glass, the life of the bulb and the luminous flux will be adversely affected. If the headlight bulb gets soiled, thoroughly clean it with a cloth moistened with alcohol or lacquer thinner.

6. Install:

• Headlight bulb holder (with the headlight bulb)

7. Install:

• Headlight bulb cover

8. Install:

• Front cowling assembly

To replace a low beam headlight bulb

1. Remove:

• Front cowling assembly

2. Remove:

• Headlight bulb cover "1"

3. Disconnect:

• Headlight coupler "1"

4. Detach:

• Headlight bulb holder "2"

5. Remove:

• Headlight bulb "3"

WARNING

Since the headlight bulb gets extremely hot, keep flammable products and your hands away from the bulb until it has cooled down.

6. Install:

• Headlight bulb

NOTICE

Avoid touching the glass part of the headlight bulb to keep it free from oil, otherwise the transparency of the glass, the life of the bulb and the luminous flux will be adversely affected. If the headlight bulb gets soiled, thoroughly clean it with a cloth moistened with alcohol or lacquer thinner.

7. Attach:

• Headlight bulb holder

8. Connect:

• Headlight coupler

9. Install:

• Headlight bulb cover

10.Install:

• Front cowling assembly

Adjusting the headlight beam

1. Adjust:

• Headlight beam (vertically)

a. Remove the adjusting screw accessing cap.

b. Turn the adjusting screw "1" in direction "a" or "b".

Direction "a" Headlight beam is raised.

Direction "b" Headlight beam is lowered.

c. Install the adjusting screw accessing cap.

See also: