Yamaha XMax YP400RA - Owner's Manual > Removing and installing panels

The panels shown need to be removed to perform some of the maintenance jobs described in this chapter. Refer to this section each time a panel needs to be removed and installed.

1. Panel A

1. Panel B
2. Panel C

1. Panel D

Panel A

To remove the panel

Remove the screws, and then pull the panel outward.

1. Panel A
2. Screw

To install the panel

Place the panel in the original position, and then install the screws.

1. Screw

Panel B

To remove the panel

1. Open the front storage compartment A.

2. Remove the screw, and then pull the panel off.

1. Panel B
2. Screw

To install the panel

Place the panel in the original position, and then install the screw.

Panel C

To remove the panel

1. Open the front storage compartment B.

2. Remove the screw, and then pull the panel off.

1. Panel C
2. Screw

To install the panel

Place the panel in the original position, and then install the screw.

Panel D

To remove the panel

1. Remove the quick fastener, and then pull the under cowling off as shown.

TIP

The quick fastener is removed by pushing the center pin in with a screwdriver, and then pulling the fastener out.

1. Cowling
2. Quick fastener

2. Remove the cowling screws, and then pull it off.

1. Screw
2. Cowling

3. Remove the battery bracket bolts, and then pull it off.

4. Remove the battery bracket and panel assembly by pulling it off as shown.

1. Panel D
2. Bracket
3. Bolt

To install the panel

1. Place the battery bracket and panel assembly in the original position, and then install the bolts.

2. Place the cowling in the original position, and then install the screws.

3. Place the under cowling in the original position, and then install the quick fastener.

TIP

To install the quick fastener, push the center pin out so that it will protrude from the fastener head, insert the fastener into the under cowling, and then push the protruding pin in until it is flush with the fastener head.

See also: