Yamaha XMax YP400RA - Owner's Manual > Storage

Short-term

Always store your scooter in a cool, dry place and, if necessary, protect it against dust with a porous cover. Be sure the engine and the exhaust system are cool before covering the scooter.

NOTICE

• Storing the scooter in a poorly ventilated room or covering it with a tarp, while it is still wet, will allow water and humidity to seep in and cause rust.
• To prevent corrosion, avoid damp cellars, stables (because of the presence of ammonia) and areas where strong chemicals are stored.

Long-term

Before storing your scooter for several months:

1. Follow all the instructions in the "Care" section of this chapter.

2. Fill up the fuel tank and add fuel stabilizer (if available) to prevent the fuel tank from rusting and the fuel from deteriorating.

3. Perform the following steps to protect the cylinder, piston rings, etc. from corrosion.

a. Remove the spark plug cap and spark plug.

b. Pour a teaspoonful of engine oil into the spark plug bore.

c. Install the spark plug cap onto the spark plug, and then place the spark plug on the cylinder head so that the electrodes are grounded. (This will limit sparking during the next step.)

d. Turn the engine over several times with the starter. (This will coat the cylinder wall with oil.)

e. Remove the spark plug cap from the spark plug, and then install the spark plug and the spark plug cap. WARNING! To prevent damage or injury from sparking, make sure to ground the spark plug electrodes while turning the engine over. [

4. Lubricate all control cables and the pivoting points of all levers and pedals as well as of the sidestand/ centerstand.

5. Check and, if necessary, correct the tire air pressure, and then lift the scooter so that both of its wheels are off the ground. Alternatively, turn the wheels a little every month in order to prevent the tires from becoming degraded in one spot.

6. Cover the muffler outlet with a plastic bag to prevent moisture from entering it.

7. Remove the battery and fully charge it. Store it in a cool, dry place and charge it once a month. Do not store the battery in an excessively cold or warm place [less than 0 ºC (30 ºF) or more than 30 ºC (90 ºF)]. For more information on storing the battery.

TIP

Make any necessary repairs before storing the scooter.

Specifications

Dimensions:

Overall length: 2190 mm (86.2 in)

Overall width: 780 mm (30.7 in)

Overall height: 1385 mm (54.5 in)

Seat height: 785 mm (30.9 in)

Wheelbase: 1565 mm (61.6 in)

Ground clearance: 103 mm (4.06 in)

Minimum turning radius: 2500 mm (98.4 in)

Weight:

Curb weight: YP400R 211 kg (465 lb)

YP400RA 215 kg (474 lb)

Engine:

Engine type: Liquid cooled 4-stroke, DOHC

Cylinder arrangement: Single cylinder

Displacement: 395 cm³

Bore × stroke: 83.0 × 73.0 mm (3.27 × 2.87 in)

Compression ratio: 10.60 : 1

Starting system: Electric starter

Lubrication system: Wet sump

Engine oil:

Recommended brand: YAMALUBE

Type: SAE 10W-30, 10W-40, 10W-50, 15W-40, 20W-40 or 20W-50

Recommended engine oil grade: API service SG type or higher, JASO standard MA

Engine oil quantity: Without oil filter element replacement: 1.50 L (1.59 US qt, 1.32 Imp.qt)

With oil filter element replacement: 1.70 L (1.80 US qt, 1.50 Imp.qt)

Final transmission oil:

Type: YAMALUBE 10W-40 or SAE 10W-30 type SE motor oil

Quantity: 0.25 L (0.26 US qt, 0.22 Imp.qt)

Cooling system:

Coolant reservoir capacity (up to the maximum level mark): 0.31 L (0.33 US qt, 0.27 Imp.qt)

Radiator capacity (including all routes): 1.38 L (1.46 US qt, 1.21 Imp.qt)

Air filter:

Air filter element: Oil-coated paper element

Fuel:

Recommended fuel: Premium unleaded gasoline (Gasohol (E10) acceptable)

Fuel tank capacity: 14.0 L (3.70 US gal, 3.08 Imp.gal)

Fuel reserve amount: 2.0 L (0.53 US gal, 0.44 Imp.gal)

Fuel injection:

Throttle body: ID mark: 5RUG 20

Spark plug(s):

Manufacturer/model: NGK/CR7E

Spark plug gap: 0.7-0.8 mm (0.028-0.031 in)

Clutch:

Clutch type: Dry, centrifugal automatic

Transmission:

Primary reduction ratio: 1.000

Final drive: Gear

Secondary reduction ratio: 6.643 (31/14 x 42/14)

Transmission type: V-belt automatic

Operation: Centrifugal automatic type

Chassis:

Frame type: Underbone

Caster angle: 28.00 º

Trail: 100 mm (3.9 in)

Front tire:

Type: Tubeless

Size: 120/70-15 M/C 56S

Manufacturer/model: MICHELIN/CITY GRIP

Manufacturer/model: SAVA/DIAMONDS MC28

Rear tire:

Type: Tubeless

Size: 150/70-13 M/C 64S

Manufacturer/model: MICHELIN/CITY GRIP

Manufacturer/model: SAVA/DIAMONDS MC28

Loading:

Maximum load: YP400R 185 kg (408 lb)

YP400RA 181 kg (399 lb)

(Total weight of rider, passenger, cargo and accessories)

Tire air pressure (measured on cold tires):

Loading condition: 0-90 kg (0-198 lb)

Front: 220 kPa (2.20 kgf/cm², 32 psi)

Rear: 250 kPa (2.50 kgf/cm², 36 psi)

Loading condition: YP400R 90-185 kg (198-408 lb)

YP400RA 90-181 kg (198-399 lb)

Front: 220 kPa (2.20 kgf/cm², 32 psi)

Rear: 250 kPa (2.50 kgf/cm², 36 psi)

Front wheel:

Wheel type: Cast wheel

Rim size: 15 x MT3.50

Rear wheel:

Wheel type: Cast wheel

Rim size: 13 x MT4.00

Front brake:

Type: Dual disc brake

Operation: Right hand operation

Specified brake fluid: DOT 4

Rear brake:

Type: Single disc brake

Operation: Left hand operation

Specified brake fluid: DOT 4

Front suspension:

Type: Telescopic fork

Spring/shock absorber type: Coil spring/oil damper

Wheel travel: 110.0 mm (4.33 in)

Rear suspension:

Type: Unit swing

Spring/shock absorber type: Coil spring/oil damper

Wheel travel: 92.0 mm (3.62 in)

Electrical system:

Ignition system: TCI

Charging system: AC magneto

Battery:

Model: GT9B-4

Voltage, capacity: 12 V, 8.0 Ah

Headlight:

Bulb type: Halogen bulb

Bulb voltage, wattage × quantity:

Headlight: 12 V, 55.0 W × 2

Tail/brake light: LED

Front turn signal light: 12 V, 10.0 W × 2

Rear turn signal light: 12 V, 10.0 W × 2

Auxiliary light: LED

License plate light: 12 V, 5.0 W × 1

Meter lighting: 12 V, 2.0 W × 3

High beam indicator light: 12 V, 1.4 W × 1

Turn signal indicator light: 12 V, 1.4 W × 2

Engine trouble warning light: 12 V, 1.4 W × 1

ABS warning light: YP400RA 12 V, 1.4 W × 1

Immobilizer system indicator light: LED

Fuses:

Main fuse: 30.0 A

Headlight fuse: 20.0 A

Signaling system fuse: 10.0 A

Ignition fuse: 10.0 A

Radiator fan fuse: 7.5 A

Hazard fuse: 10.0 A

ECU fuse: 10.0 A

ABS control unit fuse: YP400RA 10.0 A

ABS motor fuse: YP400RA 30.0 A

ABS solenoid fuse: YP400RA 20.0 A

Backup fuse: 10.0 A

Consumer information

Identification numbers

Record the vehicle identification number and model label information in the spaces provided below for assistance when ordering spare parts from a Yamaha dealer or for reference in case the vehicle is stolen.

Vehicle identification number

1. Vehicle identification number

The vehicle identification number is stamped into the frame.

TIP

The vehicle identification number is used to identify your vehicle and may be used to register it with the licensing authority in your area.

Model label

1. Model label

The model label is affixed to the location shown. Record the information on this label in the space provided. This information will be needed when ordering spare parts from a Yamaha dealer.

See also: