PIAGGIO Beverly 300ie - Service manual > Front mudguard

To remove the front mudguard, proceed as follows:

• On both sides of the vehicle, unscrew the indicated screws and remove the stanchion guard;

• Unscrew the three bolts indicated inside the mudguard;
• Detach the brake hose from the two indicated seats and remove the mudguard, pulling from the front.

Radiator fan

To remove the radiator electric fan, proceed as follows:

• Remove the front wheel housing.
• Obtain a suitably sized container and drain the cooling system by removing the indicated clamp.

  Open the expansion tank cap to facilitate draining;

• Detach the radiator from the circuit pipes;
• Unscrew the indicated screw and remove the radiator, lifting out of its seat.

Expansion tank

To remove the expansion tank, proceed as follows:

• Remove the leg shield back plate;
• Drain the cooling system by removing the indicated clamp;
• Unscrew the indicated screw and remove the expansion tank.

Battery

To access the battery, proceed as follows:

• Position the vehicle on centre stand
• Open the saddle, following the previously described procedure
• Unscrew the three screws "A" and remove the cover "B"

The battery is the electrical device that requires the most frequent attention and the most thorough maintenance.

The main points of maintenance to be observed are as follows:

WARNING

DO NOT DISCONNECT THE BATTERY CABLES WITH THE ENGINE RUNNING, THIS CAN CAUSE IRREPARABLE DAMAGE TO THE VEHICLE'S ELECTRONIC CONTROL UNIT.

WARNING

USED BATTERIES ARE HARMFUL FOR THE ENVIRONMENT.

COLLECTION AND DISPOSAL SHOULD BE CARRIED OUT IN COMPLIANCE WITH REGULATIONS IN FORCE.

Characteristic

Battery
SEALED 12V / 10Ah

See also: