Suzuki Burgman 400 - Service manual > Passing Light Switch Inspection
Inspect the passing light switch in the following procedures:
1) Remove the meter panel. Refer to "Meter Panel Removal and Installation".
2) Disconnect the left handlebar switch coupler (1).
3) Inspect the passing light switch for continuity with the tester. If any abnormality is found, replace the left handlebar switch assembly with a new one. Refer to "Handlebars Removal and Installation ".
Special tool : 09900-25008 (Multi-circuit tester set)
Tester knob indication
Continuity (
)
4) After finishing the passing light switch inspection, reinstall the removed parts.
Horn Button Inspection
Inspect the horn button switch in the following procedures:
1) Remove the meter panel. Refer to "Meter Panel Removal and Installation".
2) Disconnect the left handlebar switch coupler (1).
3) Inspect the horn button for continuity with the tester.
If any abnormality is found, replace the left handlebar switch assembly with a new one. Refer to "Handlebars Removal and Installation".
Special tool : 09900-25008 (Multi-circuit tester set)
Tester knob indication
Continuity ()
4) After finishing the horn button switch inspection, reinstall the removed parts.
Rear Brake Light Switch Inspection
Refer to "Brake Light Switch Inspection".
Front Brake Light Switch Inspection
Refer to "Brake Light Switch Inspection ".
Hazard Switch Inspection
Inspect the hazard switch in the following procedures:
1) Remove the meter panel. Refer to "Meter Panel Removal and Installation ".
2) Disconnect the right handlebar switch coupler (1) and (2).
3) Inspect the hazard switch for continuity with the tester. If any abnormality is found, replace the right handlebar switch assembly with a new one. Refer to "Handlebars Removal and Installation ".
Special tool : 09900-25008 (Multi-circuit tester set)
Tester knob indication
Continuity ()
4) After finishing the hazard switch inspection, reinstall the removed parts.
Engine Stop Switch Inspection
Inspect the engine stop switch in the following procedures:
1) Remove the meter panel. Refer to "Meter Panel Removal and Installation".
2) Disconnect the right handlebar switch coupler (1) and (2).
3) Inspect the engine stop switch for continuity with the tester. If any abnormality is found, replace the right handlebar switch assembly with a new one. Refer to "Handlebars Removal and Installation".
Special tool : 09900-25008 (Multi-circuit tester set)
Tester knob indication
Continuity ()
4) After finishing the engine stop switch inspection, reinstall the removed parts.
See also:
Suzuki Burgman 400 - Service manual > Turn Signal / Side-stand Relay
Turn Signal / Side-stand Relay Inspection Refer to "Electrical Components Location". NOTE Make sure that the battery is fully charged.
Suzuki Burgman 400 - Service manual > Starter Button Inspection
Inspect the starter button in the following procedures: 1) Remove the meter panel. Refer to "Meter Panel Removal and Installation". 2) Disconnect the right handlebar switch coupler (1) and (2).
