Suzuki Burgman 400 - Service manual > Upper Meter Panel Removal and Installation
Removal
Pull out the upper meter panel (1).
- Hooked point
Installation
Push in the upper meter panel (1).
- Hooked point
Front Leg Shield Cover Removal and Installation
Removal
1) Remove the upper meter panel. Refer to "Upper Meter Panel Removal and Installation".
2) Remove the screws.
3) Remove the front leg shield cover (1).
- Hooked point
Installation
Install the front leg shield cover in the reverse order of removal.
Wind Screen Removal and Installation
Removal
1) Remove the front leg shield cover. Refer to "Front Leg Shield Cover Removal and Installation".
2) Remove the wind screen (1).
Installation
Install the wind screen in the reverse order of removal.
Front Panel Removal and Installation
Removal
1) Open the front box and remove the fastener (1).
2) Remove the brake-lock lever (2).
3) Remove the front panel (3).
Installation
Install the front panel in the reverse order of removal.
Meter Panel Removal and Installation
Removal
1) Remove the wind screen. Refer to "Wind Screen Removal and Installation".
2) Remove the screws and detach the meter panel assembly (1) forward.
3) Disconnect the meter coupler (2) and remove the meter panel.
Installation
Install the meter panel in the reverse order of removal.
Front Leg Shield Removal and Installation
Removal
1) Remove the meter panel assembly. Refer to "Meter Panel Removal and Installation".
2) Remove the left and right front floor mats (1) and screws (2).
3) Remove the screws and fasteners.
4) Remove the front leg shield (3) by disconnecting the turn signal light coupler (4), position light couplers (5) and headlight couplers (6).
See also:
Suzuki Burgman 400 - Service manual > Repair Instructions
Exterior Parts Components Wind screen Upper meter panel Meter panel assembly Front panel Front leg shield cover Front leg shield Front box assembly Lower leg shield Frame cover (RH) Footboard (RH) Center leg cover (RH) Side leg shield (RH) Center frame cover Front frame cover Frame cover (LH) Lower frame cover Center leg cover Footboard (LH) Side leg shield (LH) Under cover Front reflex reflector (For E-03, 28, 33) Adhere the front reflex reflector on to the front leg shield. Set the reflector to the edge of front leg shield. Align the projection of reflector with the joint part of meter panel and front box. Fuel lid Front box inner cover (LH) Battery cover Front box inner cover (RH) Front box Cushion Fuel lid Inner cushion Cushion Front box lid 0 mm 0 - 3 mm (0 - 0.12 in) 4 mm (0.16 in) Front panel box lid Cushion Front panel box 2 mm (0.08 in) Do not exchange the right one and left one.
Suzuki Burgman 400 - Service manual > Side Leg Shield Removal and Installation
Removal 1) Remove the left and right rear floor mats (1), fasteners and screws.
