PIAGGIO Beverly 300ie - Service manual > Electrical system
- Components arrangement
- Electrical system installation
- Checks and inspections
- Ignition circuit
- Starter motor
- Battery installation
- Connectors
See also:
PIAGGIO Beverly 300ie - Service manual > Braking system
Level check The front and rear brake fluid reservoirs are both positioned on the handlebar. Proceed as follows: Rest the vehicle onto the centre stand, with the handlebar centred. Check the fluid level through the sight glass "A".
PIAGGIO Beverly 300ie - Service manual > Components arrangement
Starter switch: remove the legshield to reach them. Immobilizer antenna: remove the legshield to reach them. Regulator connector: remove the legshield to reach them. Spark plug: remove the spark plug inspection cover to access the spark plug. Battery: lift the saddle and remove the battery cover to access the battery. Fuses: lift the saddle and remove the battery cover to access the battery. relays: lift the saddle and remove the battery cover to access the battery. Diagnostic socket: lift the saddle and remove the battery cover to access the battery. Control unit: lift the saddle and remove the engine inspection cover to access the ECU. Saddle actuator: to reach it, remove the left fairing. H.V. coil: remove the helmet compartment to reach it. Starter relay: to reach it, remove the left fairing. Stand button: remove the left footrest to reach it. Stator connector: remove the central chassis cover to reach them. Roll-over sensor: remove the central chassis cover to reach them. Fuel pump: remove the central chassis cover to reach them. Fuel level transmitter: remove the central chassis cover to reach them. Horn: remove the front wheel housing to reach it. Temperature sensor: remove the legshield to reach them. LV socket: remove the legshield to reach them. Regulator: remove the legshield to reach them. Turn indicator device: remove the legshield to reach them.
