PIAGGIO Beverly 300ie - Service manual > Engine
- Automatic transmission
- Transmission cover
- Inspecting the clutch drum
- Removing the driven half-pulley bearing
- Refitting the clutch
- Drive-belt
- End gear
- Flywheel cover
- Flywheel and starting
- Starter gear rim
- Cylinder assy. and timing system
- Refitting the cylinder
- Inspecting the cam shaft
- Crankcase - crankshaft
- Lubrication
- Oil pump
See also:
PIAGGIO Beverly 300ie - Service manual > Engine from vehicle
Exhaust assy. Removal Remove the RH footrest. Remove the Lambda probe from its support and disconnect it. Cut the fastening clamp on the lambda probe cable. Undo the two exhaust manifold fixings on the head. To unscrew the nuts that fix the silencer flange to the head properly, use a jointed wrench that allows, according to the travel direction, to get also at the right nut. That is difficult to do with a traditional straight wrench. Unscrew the three screws fastening the heat shield to the silencer; Unscrew the three screws "A" fastening the silencer to the silencer mounting bracket. Remove the full silencer unit. Remove the lambda probe from the manifold.
